Stop choosing between cooling capacity and control. This water-cooled power pack combines robust refrigeration output with precise circulation to support continuous draft operations in high-traffic environments. Practical engineering ensures dependable cold transfer and simplified serviceability for busy food service, hospitality, and institutional programs.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug power and drain glycol per manufacturer specs. Remove cover and wipe interior with a mild detergent solution. Clean condenser and compressor fins with a soft brush to remove grease and dust. Flush pumps and lines with approved cleaner, then rinse until clear. Inspect seals, fittings and the 3/8" inlet for wear; replace if needed. Verify digital thermostat settings and dry sight glass before refilling the 11.5 gallons glycol bath. Reconnect power and test operation.#@@#Additional Info#@#Micro Matic's MMPP4307-PKG-3-WC power pack features a 1.5 HP compressor, 11,500 BTU cooling, and an 11.5 gallon glycol bath.#@@#General Info#@#Description #@#
Stop choosing between cooling capacity and control. This water-cooled power pack combines robust refrigeration output with precise circulation to support continuous draft operations in high-traffic environments. Practical engineering ensures dependable cold transfer and simplified serviceability for busy food service, hospitality, and institutional programs.
#@@# 37 Inch Footprint#@#
Installers benefit from a compact footprint at 37.13 inches wide, fitting most backbar spaces while providing substantial internal volume. Designers can plan layouts knowing the unit measures 28.75 inches deep and 31.5 inches high for predictable integration.
#@@# Glycol Bath Control#@#
A sealed 11.5-gallon glycol bath with an exterior sight glass enables consistent temperature stability and rapid thermal recovery under heavy pour loads. Technicians can adjust the digital thermostat to maintain the target chill and monitor fluid levels through the sight glass for routine maintenance.
#@@# Circulation Redundancy#@#
Three vane circulating pumps, each driven by a 1/3 HP motor, provide distributed flow to multiple draft lines and reduce the risk of single point failure. Operators can route runs to separate service zones and sustain dispensing performance during partial maintenance.
#@@# Compressor Performance#@#
A 1.5 HP compressor rated at 11,500 BTU manages thermal load efficiently in water-cooled operation and supports extended run cycles. Engineers will appreciate the 208/230v 60 Hz single-phase electrical design that aligns with standard commercial power infrastructure.
#@@# Refrigerant Specification#@#
The system uses R-404A refrigerant and arrives with cETLus certification to meet local safety standards and inspection requirements. Maintenance personnel will note the 3/8 inch female inlet for straightforward water loop connections.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect condenser water lines weekly for scale and debris; flush with approved descaler if flow drops or temperature rises. Verify pump seals and motor mounts monthly; tighten fasteners and replace worn seals to prevent leaks. Measure glycol concentration quarterly and maintain 30–40% by volume; document in liters and gallons. Clean exterior sight glass and cabinet insulation with mild detergent; avoid abrasives.
