Handle high-volume slicing tasks with precision and reliability. This 8mm slicing disc fits Master SKY, PA-7, and PA-7 PRO food processors to deliver uniform 5/16 inch slices for consistent plating and portion control. Food service operators benefit from a hardened stainless steel cutting surface and exact tooth spacing that maintain slice accuracy across batches.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug the food processor and remove the disc. Inspect the Skyfood E8 8mm slicing disc for nicks or warping. Clean with a mild detergent and warm water using a non-abrasive brush; rinse thoroughly. Sanitize with an approved CSA-compliant solution per label instructions and air dry. Reassemble only when dry and aligned. Clean processor housing, feed chute, and seals daily to prevent bacteria, grease buildup, equipment failure, and failed inspections.#@@#Additional Info#@#Skyfood's E8 8mm slicing disc fits Master SKY, PA-7, and PA-7 PRO food processors, slicing to 5/16" thickness for consistent portioning. It weighs 3 pounds, installs quickly, and meets CSA standards.#@@#General Info#@#Description #@#
Handle high-volume slicing tasks with precision and reliability. This 8mm slicing disc fits Master SKY, PA-7, and PA-7 PRO food processors to deliver uniform 5/16 inch slices for consistent plating and portion control. Food service operators benefit from a hardened stainless steel cutting surface and exact tooth spacing that maintain slice accuracy across batches.
#@@# Slicing Consistency#@#
Engineered for repeatable 8mm cuts, the disc produces uniform slices that support portion control and reduce product giveaway. Chefs preserve presentation standards while staff maintain throughput during peak service periods.
#@@# Durable Construction#@#
Manufacturers use hardened stainless steel to resist wear and retain edge geometry over extended use cycles. Kitchens lower replacement frequency and sustain slice quality under continuous operation.
#@@# Compatibility Fit#@#
Designed to mount directly on Master SKY, PA-7, and PA-7 PRO hubs, the disc installs without adapters and aligns to factory tolerances. Operators minimize downtime during changeovers and ensure safe, secure attachment during processing.
#@@# Throughput Performance#@#
The disc supports high-capacity processing runs by maintaining cut quality at elevated feed rates and consistent motor load. Managers achieve steady production output while protecting machine efficiency.
#@@# Cleaning and Maintenance#@#
The flat disc geometry simplifies rinsing and sanitizing, and the single-piece construction removes crevices that harbor residue. Staff complete sanitation cycles faster and meet health code requirements with less labor time.
#@@# Safe Operation#@#
Precision manufacturing reduces vibration and imbalance, which cuts noise and minimizes wear on bearings and seals. Supervisors extend machine lifespan and improve operator comfort during long processing shifts.
#@@# Weight and Handling#@#
At approximately 3 pounds, the disc balances rigidity with manageable mass for rapid installation by a single technician.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Use the Skyfood E8 8mm slicing disc with Master SKY, PA-7 and PA-7 PRO machines. Inspect blades before each shift and replace discs that show nicks or bending. Lubricate drive shaft per manufacturer intervals and torque fasteners to specified values. Clean discs with warm water and mild detergent; dry completely to prevent corrosion. Verify alignment after reassembly and run a short calibration batch to confirm consistent 8mm slices.
