Stop compromising efficiency for compatibility. This hubless machine plate fits #12 grinder hubs and delivers consistent 0.81 inch (13/16") hole sizing for uniform grind output, supporting steady throughput in busy kitchens. Designed in carbon steel for repeated use, it installs quickly and aligns precisely with standard #12 hubs to reduce downtime and maintain product consistency.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug the grinder and remove the plate. Scrub the Omcan USA 11244 #12 0.81" carbon steel plate with warm, soapy water and a soft brush to remove food particles and grease. Rinse thoroughly and dry with a clean cloth to prevent rust. Inspect the hub and sealing surfaces for wear; replace if damaged. Reassemble only when all parts are fully dry. Maintain regular cleaning to prevent contamination, reduce fire risk from grease buildup, lower energy use, and avoid equipment failure.#@@#Additional Info#@#Omcan USA 11244 is a #12 hubless carbon steel plate with a 13/16" (20 mm) hole pattern for meat grinders. It fits standard #12 hubs, weighs 1 pound, resists wear, and meets CSA standards for commercial kitchens.#@@#General Info#@#Description #@#
Stop compromising efficiency for compatibility. This hubless machine plate fits #12 grinder hubs and delivers consistent 0.81 inch (13/16") hole sizing for uniform grind output, supporting steady throughput in busy kitchens. Designed in carbon steel for repeated use, it installs quickly and aligns precisely with standard #12 hubs to reduce downtime and maintain product consistency.
#@@# Hubless Fit#@#
This plate fits #12 hubs without a raised center, allowing direct contact with the grinder shaft for efficient power transfer. Installers will find alignment straightforward, minimizing retrofit time when replacing worn plates.
#@@# Consistent Aperture#@#
Machined holes measure 0.81 inches (13/16") to produce uniform particle size across runs. Operators achieve predictable texture control for sausage, burger, or bulk grind applications, improving portion consistency.
#@@# Carbon Steel Construction#@#
Carbon steel offers structural strength for sustained mechanical stress during continuous operation. Kitchen staff will notice the plate resists distortion under load, preserving hole geometry and maintaining grind quality.
#@@# Low Mass Profile#@#
The hubless design reduces unnecessary material and mass at the center, keeping rotational balance tight. Technicians encounter reduced vibration and quieter operation at high throughput rates.
#@@# Standard Compatibility#@#
Engineered for standard #12 grinder systems, the plate integrates with common meat choppers and grinders used in restaurants, institutions, and foodservice plants. Maintenance teams benefit from interchangeability with existing tooling, simplifying spare inventory.
#@@# Serviceability#@#
The plate ships as a single-piece component that technicians can remove and inspect without special tools. Managers gain predictable maintenance cycles, since visual wear indicators appear quickly and replacement restores original performance.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect the Omcan USA #12 hubless 13/16" carbon steel plate before use and after each shift for wear, burrs, or deformation. Clean with warm water and neutral detergent, scrub with a nonabrasive brush, and rinse thoroughly; sanitize per facility protocol. Dry immediately to prevent surface oxidation and store in a dry, ventilated rack. Regrind edges with a fine stone if minor burrs appear; replace plate if cracks or permanent warping occur.
