Unit measures approximately 15.9 inches in width and height with a 16.9-inch depth and weighs 30.6 pounds, enabling placement on counters without structural modification. Technicians relocate or store the slicer as needed for evolving kitchen layouts.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug the slicer and lock the guard before cleaning. Remove blade ring and food tray; wash parts in warm, soapy water and sanitize with a CSA-approved solution. Wipe die-cast aluminum surfaces with a non-abrasive cleaner; avoid soaking motor housing. Use a soft brush on the 8" blade and built-in sharpener; rinse and dry thoroughly. Reassemble when all parts are dry. Clean daily to prevent bacteria, reduce fire risk from grease, lower energy use, and extend equipment life.#@@#Additional Info#@#Omcan USA 39467 offers an 8" die-cast aluminum electric manual-feed meat slicer with a 1/5 HP motor, 110v/60Hz power, built-in sharpener, and fixed ring guard, ETL Sanitation and cETLus listed for commercial kitchens, weighing 30.6 pounds.#@@#General Info#@#Description #@#
Unit measures approximately 15.9 inches in width and height with a 16.9-inch depth and weighs 30.6 pounds, enabling placement on counters without structural modification. Technicians relocate or store the slicer as needed for evolving kitchen layouts.#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect blade alignment weekly and operate the built-in sharpener per manufacturer guidelines to maintain cutting precision. Lubricate slide rods with food-grade lubricant monthly and clean die-cast aluminum surfaces after each shift using a mild detergent and warm water; avoid abrasive cleaners. Verify CSA and ETL sanitation labels remain legible and confirm electrical connections at 110v for continuity. Replace worn gaskets and check belt tension quarterly to ensure consistent performance.
