Stop compromising line speed for connector reliability. This reducing elbow connector ensures compact, press-fit connections for fluid systems while maintaining flow and structural integrity in tight assemblies. Its 0.5" to 5/16" reducing geometry optimizes layouts for confined spaces common in bar back, kitchen, and institutional setups.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug fittings before cleaning. Disconnect tubing from the Micro Matic PI211610S John Guest reducing elbow connector. Wipe exterior with a mild detergent and warm water, using a soft brush for internal bores. Rinse thoroughly with potable water and air-dry or blow-dry with clean compressed air. Reassemble when completely dry. Clean weekly or after heavy use to prevent bacteria, grease buildup, and avoid flow restrictions.#@@#Additional Info#@#Micro Matic PI211610S John Guest reducing elbow enables 0.5" to 5/16" transitions in draft systems. Designed for beverage dispensing, it offers secure push-fit connections, sanitary flow, and faster installation.#@@#General Info#@#Description #@#
Stop compromising line speed for connector reliability. This reducing elbow connector ensures compact, press-fit connections for fluid systems while maintaining flow and structural integrity in tight assemblies. Its 0.5" to 5/16" reducing geometry optimizes layouts for confined spaces common in bar back, kitchen, and institutional setups.
#@@# Reducing Elbow#@#
The 90-degree reducing elbow transitions from 0.5" to 5/16" tubing, routing lines around obstacles without kinking. Designers achieve compact routing while preserving bore continuity for predictable flow rates.
#@@# Push-Fit Retention#@#
John Guest push-fit retention secures tubing without clamps or tools, enabling fast service and repeatable installation torque. Technicians save labor time and reduce leak points during assembly or maintenance.
#@@# Corrosion-Resistant Body#@#
The connector’s engineered polymer resists typical bar and kitchen fluids, limiting degradation from cleaning agents and moisture. Facilities reduce replacement frequency under routine sanitation protocols.
#@@# Low-Profile Geometry#@#
The compact elbow profile minimizes space demand behind taps, refrigeration lines, and steam fittings, enabling installation in crowded compartments. Operators conserve cabinet depth and improve servicing access.
#@@# Flow Optimization#@#
Internal passage ensures smooth transitions between diameters, reducing turbulence and pressure loss. Engineers maintain dispense performance for draft systems and auxiliary lines where consistent flow matters.
#@@# Compatibility Range#@#
The component mates with standard 0.5" and 5/16" flexible tubing used in dispensing and refrigeration circuits. Procurement teams simplify inventory by selecting a connector compatible with widely adopted tube sizes.
Since 1998, company experience supports product reliability in commercial foodservice environments where uptime and sanitary performance matter.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Maintain the Micro Matic PI211610S John Guest reducing elbow connector by inspecting connections weekly for leaks and ensuring tubing seats fully against barbs. Flush lines monthly with approved cleanser and purge with potable water until clear. Remove mineral buildup using a soft brush and mild descaler; avoid abrasives that damage seals. Lubricate O-rings with food-grade silicone and replace worn seals annually. Document service dates for compliance and traceability.
