Component manufacturing meets industry fabrication norms and references CSA where applicable for electrical and safety traceability in related assemblies. Procurement teams document compliance and streamline audit readiness for institutional accounts.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug faucet assemblies and close gas and beverage valves. Remove dual tap shank and soak in a mild detergent solution for 10–15 minutes. Scrub interior and 6" exterior surfaces with a soft brush, paying attention to 3/16" ID passages. Rinse with potable water until no suds remain. Sanitize per CSA or local code using approved sanitizer at specified concentration. Air dry fully and inspect seals before reinstalling to prevent leaks, contamination, and equipment failure.#@@#Additional Info#@#Micro Matic BE-DF6-3 dual tap shank is 6" long with a 0.19" internal diameter, designed for draft beer systems. Its CSA-compatible stainless construction resists corrosion and ensures consistent flow for commercial beverage service.#@@#General Info#@#Description #@#
Component manufacturing meets industry fabrication norms and references CSA where applicable for electrical and safety traceability in related assemblies. Procurement teams document compliance and streamline audit readiness for institutional accounts.#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect the Micro Matic BE-DF6-3 dual tap shank weekly and remove residue to prevent flow issues. Use food-grade sanitizer and warm water to flush both lines; circulate for five minutes, then flush with potable water until clear. Disassemble fittings monthly and check O-rings for hardening or cracking; replace damaged seals. Torque fittings per manufacturer specs to prevent leaks. Document maintenance, date of parts replaced, and keep spare seals and clamps on hand.
