Stop compromising on system resilience for compact installation. This remote condensing unit delivers consistent cooling capacity in commercial refrigeration setups while minimizing the on-site footprint and simplifying maintenance planning. Designed for coordinated installations where three condensing units operate in parallel, it supports uninterrupted operation in high-demand food service environments.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug equipment and remove food nearby. Wear gloves and eye protection. Vacuum condenser fins to remove debris, then brush with a soft coil brush. Mix mild detergent in warm water (use gallons or liters as needed) and wipe surfaces; avoid abrasive pads. Clean vents and filters weekly to prevent grease buildup and fire risk. Sanitize food-contact areas with EPA-approved sanitizer to reduce bacteria and meet CSA and health inspection standards. Reconnect power after full drying.#@@#Additional Info#@#Taylor Company RC35 50HZ remote condensing unit offers air-cooled performance with R-449A refrigerant, needs 6" clearance on three sides, operates at 380/415 volts, weighs 205 pounds, and fits commercial ice equipment installations.#@@#General Info#@#Description #@#
Stop compromising on system resilience for compact installation. This remote condensing unit delivers consistent cooling capacity in commercial refrigeration setups while minimizing the on-site footprint and simplifying maintenance planning. Designed for coordinated installations where three condensing units operate in parallel, it supports uninterrupted operation in high-demand food service environments.
#@@# Remote Mounting#@#
Mount the unit outdoors to relocate heat and reduce kitchen load. Installers receive a compact package with a depth of 26.75 inches and a width of 25.63 inches, fitting tight rooftop or alleyway placements while maintaining the specified three-side clearance of 6 inches for airflow.
#@@# High-Voltage Design#@#
Specify the 380/415 volts configuration to integrate with three-phase electrical systems common in large facilities. Electricians observe CSA and cULus certifications for compliance and wire the unit to match existing distribution panels for balanced load sharing.
#@@# Refrigerant Performance#@#
Utilize R-449A refrigerant to achieve efficient heat transfer and compatible pressure profiles with modern ice machine compressors. Technicians note the air-cooled architecture and refrigeration type to size piping runs and optimize charge for long run cycles.
#@@# Weight and Service Access#@#
Plan for a unit mass of 205 pounds during delivery and placement operations to ensure proper rigging and safe handling. Service personnel gain straightforward access to components for routine checks, reducing downtime during scheduled maintenance windows.
#@@# Modular Deployment#@#
Coordinate deployment in sets of three to meet required system redundancy and capacity scaling for large kitchens, hospitals, or campus dining services. Engineers leverage the modular approach to stage phased installations and limit interruptions to existing refrigeration loads.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect condenser coils weekly and remove debris for heat transfer; clean with a soft brush and low-pressure water spray while powered down. Verify electrical connections monthly and tighten terminals on 380/415 volts circuits; document torque values per CSA guidelines. Monitor refrigerant charge for R-449A and repair leaks; calibrate pressure switches and replace defective sensors.