Stop risking service interruptions with inferior connections. This gas connector hose kit combines a stainless steel braided core with an extruded protective coating to deliver secure, flexible fuel delivery for commercial kitchens. Designed for institutional and high-use environments, the assembly simplifies installation and reduces the likelihood of leak-related downtime.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug gas appliances and shut off supply. Inspect the T&S Brass HG-4C-72S connector for damage. Detach following manufacturer steps, drain residual gas per protocol, and clean exterior braid with a mild detergent and soft brush. Rinse and dry completely. Check SwiveLink swivels, quick disconnect, and 90° elbows for debris; clear with compressed air if needed. Reinstall and test for leaks with approved soapy solution. Maintain records to pass CSA and health inspections.#@@#Additional Info#@#T&S Brass HG-4C-72S Safe-T-Link gas connector hose has a 1/2" connection and 72" stainless steel braid with plastic coating, quick disconnect, two SwiveLink swivels, two 90° elbows, and a restraining device for secure gas line installations.#@@#General Info#@#Description #@#
Stop risking service interruptions with inferior connections. This gas connector hose kit combines a stainless steel braided core with an extruded protective coating to deliver secure, flexible fuel delivery for commercial kitchens. Designed for institutional and high-use environments, the assembly simplifies installation and reduces the likelihood of leak-related downtime.
#@@# Half Inch Connection#@#
The hose uses a 1/2" internal diameter connection that matches standard commercial gas lines, enabling direct integration with existing fixtures. Installers appreciate the consistent sizing because it eliminates the need for adapters and maintains rated flow characteristics.
#@@# Seventy Two Length#@#
The assembly measures 72" overall length, providing ample reach for typical range-to-line installations while allowing tidy routing behind equipment. Technicians gain installation flexibility without compromising clearance or creating tension on fittings.
#@@# Reinforced Braid#@#
A stainless steel braid underlies the extruded coating to provide mechanical strength and abrasion resistance where kitchens demand durability. Operators benefit from extended service life and reduced replacement frequency compared with unreinforced hoses.
#@@# Quick Disconnect#@#
A single quick disconnect on the unit permits fast service or replacement without disturbing adjacent connections. Maintenance teams save time during routine inspections and can isolate devices quickly to limit operational impact.
#@@# Swivel Elbows#@#
Two SwiveLink swivels and two 90° elbows permit rotational freedom at both ends and tight cornering near fixtures. Installers achieve leak-free joints under stress and can orient the hose for minimal bending stress, preserving seal integrity.
#@@# Restraining Device#@#
The kit includes a restraining device to secure the hose against movement and comply with common safety practices.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Install the T&S Brass HG-4C-72S Safe-T-Link gas connector with secure fittings and verify 1/2" connections and 72" length before service. Inspect the plastic coated stainless steel braid monthly for abrasion, cuts, kinks, or coating breach. Test quick disconnect and SwiveLink swivels for smooth operation and replace worn swivels immediately. Confirm restraining device integrity and torque fittings per manufacturer torque specs. Pressure-test after any repair.