Fabrication aligns with industry expectations for commercial plumbing hardware and carries CSA-compatible design attributes for straightforward inspection. Procurement officers secure a dependable part that supports regulatory review and operational continuity.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug equipment before cleaning. Rinse spray valve with warm water to remove debris, then apply a mild detergent solution and scrub with a soft brush. Flush thoroughly until water runs clear. Inspect seals and replace worn parts. Clean surrounding fittings and remove grease from vents and hoods to reduce fire risk. Maintain condenser coils and dry all surfaces to preserve efficiency and prevent corrosion. Regular cleaning reduces contamination, outages, and energy use.#@@#Additional Info#@#T&S Brass B-0107-C35 pre-rinse spray valve delivers 0.65 gpm with a brass body and a 35° spray face for targeted rinsing; technicians easily install this 1.02-pound unit, and CSA-compatible components ensure commercial kitchen durability.#@@#General Info#@#Description #@#
Fabrication aligns with industry expectations for commercial plumbing hardware and carries CSA-compatible design attributes for straightforward inspection. Procurement officers secure a dependable part that supports regulatory review and operational continuity.#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect spray valve daily for leaks and proper spray pattern. Lubricate O-rings quarterly with food-grade silicone to preserve seals. Disassemble weekly under manufacturer guidelines; soak brass components in mild detergent solution and rinse with potable water. Replace worn washers and O-rings immediately to prevent water waste. Verify gpm at installation and adjust supply pressure to 20–30 psi for consistent 0.65 gpm output. Record maintenance in CSA-compliant log.
