This wall-mounted roll towel dispenser delivers consistent, controlled hand-drying in high-traffic restrooms and service areas while resisting impact and moisture. Engineers designed it for institutional settings to reduce maintenance calls and keep staff focused on operations.
LongDescription#@#NA#@@#Cleaning Instructions#@#Mount dispenser on a clean, dry wall at recommended height. Empty spent roll, wipe interior and lever with a soft cloth and mild detergent, then rinse. Sanitize high-touch surfaces (lever, front cover, chair backs nearby) with EPA-registered disinfectant following label dwell time. Inspect seals and replace broken parts. Clean weekly or after spills to prevent contamination, deter pests, maintain appearance, and support CSA compliance.#@@#Additional Info#@#San Jamar T1100TBK towel dispenser is 12.94"W x 9.25"D x 16.5"H and fits one 8" wide roll up to 8" diameter.#@@#General Info#@#Description #@#
This wall-mounted roll towel dispenser delivers consistent, controlled hand-drying in high-traffic restrooms and service areas while resisting impact and moisture. Engineers designed it for institutional settings to reduce maintenance calls and keep staff focused on operations.
The unit uses break-resistant plastic to survive knocks and repeated handling without cracking. Designers selected a translucent pearl black finish to conceal scuffs while allowing quick visual checks of roll status.
Installers can mount the dispenser on limited wall space thanks to a 12.94 inch width and 9.25 inch depth that minimize projection. Facilities with narrow corridors or dense fixture layouts retain circulation space and comply with accessibility planning.
Operators get positive, manual dispensing from a handle that reduces overconsumption compared with free-spinning holders. Maintenance teams appreciate consistent tear points that limit paper waste and lower supply spend.
Service personnel load one 8 inch wide roll up to 8 inch diameter, which simplifies inventory and stocking procedures. Managers will find predictable run times for each refill cycle, aiding labor scheduling for custodial staff.
Technicians install the dispenser as a surface-mounted unit to support concrete, drywall, or tile backings without recessed rough-in. Facilities avoid wall cavity modifications and maintain finishes while achieving secure placement.
The assembly weighs approximately 5.45 pounds, enabling a single technician to remove and replace units during routine cleaning or refurbishment. Staff complete service tasks faster and reduce downtime in high-demand areas.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect the San Jamar T1100TBK Towel Dispenser weekly and tighten mounting hardware to maintain secure wall-mounted installation. Remove the roll and wipe interior surfaces with a mild detergent solution; rinse and dry before refilling to prevent contamination. Lubricate the lever action handle monthly with a silicone spray to ensure smooth manual dispensing. Replace broken components immediately with CSA‑compliant parts and document service dates for traceability.