This manual disposer control delivers reliable on/off switching for commercial sink disposals, engineered to support high-use environments while protecting electrical systems and staff. Installers and service managers will value the straightforward wiring and compatibility with common disposer motors.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug power and lock out circuit before service. Remove disposer cover and verify MS-1 fits H or A series units. Wipe exterior with non-abrasive cleaner and soft cloth. Clean contacts with electrical contact cleaner and inspect wiring for frays; replace damaged wires. Flush enclosure drain and dry interior before reassembly. Test manual on/off switch at 115 or 230 volts, 1-ph. Regular cleaning reduces bacteria, fire risk, energy use, breakdowns, and helps pass CSA inspections.#@@#Additional Info#@#RedGoat MS-1 Disposer Control offers a manual on/off switch for 3/4 to 2 HP disposers, compatible with 115 or 230 volt, 1-phase systems.#@@#General Info#@#Description #@#
This manual disposer control delivers reliable on/off switching for commercial sink disposals, engineered to support high-use environments while protecting electrical systems and staff. Installers and service managers will value the straightforward wiring and compatibility with common disposer motors.
NEMA 4 watertight construction protects internal components from splashes and washdown environments. Technicians will install this unit in wet areas without adding extra protective housings.
Cast aluminum housing and cover provide corrosion resistance and mechanical strength in demanding kitchen settings. Facilities managers will note reduced wear and fewer replacements compared with plastic alternatives.
Manual on/off non-reversing switch offers direct, intuitive control for staff and reduces training time. Operators will gain fast, predictable activation without electronic delays.
Designed for 3/4 to 2 HP disposers, the control supports a broad range of common commercial motor sizes. Maintenance teams will pair this control with multiple disposer models to simplify spare part inventories.
Accepts 115 or 230 volt, single-phase power to match facility electrical systems. Electricians will wire the unit without voltage converters, saving installation time and cost.
Engineered for specific series disposers to ensure secure mechanical and electrical integration. Service personnel will achieve consistent connections and maintain manufacturer-aligned performance.
Measures approximately 3 inches by 3.44 inches by 5.25 inches and weighs about 4 pounds, allowing installation in tight spaces near sinks and chases. Plumbers will route conduits and mount the control without major alterations to existing layouts.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect electrical connections monthly and tighten terminals to prevent arcing. Clean the NEMA 4 watertight enclosure exterior with a damp cloth and nonabrasive detergent; avoid solvent contact with gaskets. Verify manual on/off switch operation under load and replace worn actuators promptly. Lubricate mounting hardware with a light oil every six months and torque fasteners per manufacturer specification. Record maintenance actions and dates for CSA compliance and warranty tracking.