Stop wasting service time on unreliable controls. This electrical kit ensures consistent operation for 240V systems, restoring switching performance with precise fit and rated components. Food service operators and maintenance teams will reduce downtime and protect kitchen throughput with a repair solution engineered for commercial environments.
LongDescription#@#NA#@@#Cleaning Instructions#@#Wipe the kit with a mild detergent and warm water, then disinfect high-touch zones like handles and covers with an EPA-registered sanitizer following label dwell time. Rinse nonporous surfaces and dry thoroughly. Inspect electrical connectors for corrosion; tighten fasteners as needed. Clean daily in service areas to prevent cross-contamination, deter pests, and maintain compliance with CSA and health-code surface standards.#@@#Additional Info#@#PartsTown R02.01.102.00 kit provides a 240V infinite switch for commercial cooking equipment, measuring 6.5" wide, 1.45" high, and weighing 0.26 pounds; technicians install it to restore temperature control and ensure CSA compliance.#@@#General Info#@#Description #@#
Stop wasting service time on unreliable controls. This electrical kit ensures consistent operation for 240V systems, restoring switching performance with precise fit and rated components. Food service operators and maintenance teams will reduce downtime and protect kitchen throughput with a repair solution engineered for commercial environments.
#@@# Compact Dimensions#@#
Dimensions measure 6.5 by 6.5 by 1.45 inches, allowing technicians to install the unit in tight equipment cavities without modification. Field teams save time because the kit aligns with standard mounting footprints used across restaurant and institutional equipment.
#@@# Commercial Rating#@#
Engineered for 240V line service, the kit meets the voltage requirements typical in high-capacity cooking equipment and ancillary systems. Facilities managers gain predictable electrical behavior under continuous load during peak service periods.
#@@# Component Integrity#@#
Manufactured parts use materials sized for repeated cycles, reducing failure rates compared with generic replacements. Maintenance staff benefit from predictable lifecycle performance and fewer emergency service calls.
#@@# Service Friendly#@#
Design includes accessible terminals and straightforward wiring paths, enabling qualified technicians to complete swaps in minimal time. Operation resumes faster, limiting revenue loss during maintenance windows.
#@@# Installation Fit#@#
Form factor and connector spacing match common OEM layouts, simplifying retrofits across multiple equipment models. Procurement teams avoid special-order complications and standardize parts across locations.
#@@# Lightweight Profile#@#
The assembly weighs 0.26 pounds, which simplifies handling during installation and reduces strain for service personnel. Logistics teams experience easier storage and transport when stocking parts for multiunit facilities.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect electrical connections monthly for secure terminals and absence of corrosion. Use a multimeter to verify 240V supply and continuity per CSA guidelines. Clean switch housing with dry compressed air; avoid liquid cleaners. Replace damaged insulation and fasteners immediately. Lubricate moving contacts with manufacturer-approved dielectric lubricant sparingly. Document maintenance actions and part number HTR02.01.102.00 for traceability and reorder planning.
