This component restores reliable mixing action in commercial mixers while minimizing service time and aligning with busy production schedules. Intended for food service operators, maintenance teams, and kitchen managers, this replacement part meets precise dimensional requirements to ensure consistent performance.
LongDescription#@#NA#@@#Cleaning Instructions#@#Wipe the SEAL-DRIVE SHAFT BEATER with a mild detergent and a soft cloth; avoid abrasive pads. Rinse with potable water and dry immediately to prevent corrosion. Sanitize high-touch zones such as handles and mounting interfaces using an approved sanitizer following label dilution; allow contact time per directions. Inspect seals and fasteners; replace damaged parts. Cleaning prevents contamination of clean items and hands, shapes customer perception, and extends serviceable life.#@@#Additional Info#@#PartsTown CRPIC177120260 seal-drive shaft beater fits commercial mixers, designed for durable torque transfer and precise agitation. It measures 1.1" length, 1.05" width, 0.45" height, and weighs 0.01 pounds, aiding consistent batch mixing.#@@#General Info#@#Description #@#
This component restores reliable mixing action in commercial mixers while minimizing service time and aligning with busy production schedules. Intended for food service operators, maintenance teams, and kitchen managers, this replacement part meets precise dimensional requirements to ensure consistent performance.
Designed to provide a fluid-tight interface between the rotating shaft and gearbox, this seal prevents ingredient leakage and protects internal components. Accurate sealing reduces contamination risk and supports compliance with sanitation protocols.
Engineered with a 1.1 inch length specification and balanced mass, the shaft delivers stable rotational transfer while minimizing vibration. Reduced oscillation preserves mixer bearings and extends the life of adjacent components.
Machined contact surfaces accept standard beater attachments and ensure secure coupling during high-torque cycles. Consistent engagement prevents slippage that leads to inconsistent product texture and waste.
With a height of 0.45 inches and a width of 1.05 inches, the form factor fits within confined gearbox cavities and supports rapid installation. Technicians can replace the component without modifying existing housings or performing extended adjustments.
Weighing approximately 0.01 pounds, the component imposes minimal inertial load on motor assemblies, supporting efficient power transfer. Lower rotational mass reduces power draw during startup and contributes to predictable motor current profiles.
Manufactured for compatibility with service parts and identified by manufacturer part number CRPIC177120260, the unit integrates with established replacement inventories. Clear identification aids procurement teams and streamlines stocking practices to reduce downtime.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect the IC177120260 SEAL-DRIVE SHAFT BEATER weekly for wear and contamination. Remove unit per manufacturer guidance and wash in warm, soapy water; rinse and dry thoroughly before reinstallation. Lubricate drive interfaces with food-grade grease at intervals recommended by PartsTown. Verify seals for cracks and replace immediately if compromised. Record maintenance actions and operating hours to schedule preventive replacements and ensure reliable service.