Stop compromising uptime for convenience. This motor seal restores drive integrity in mixers and rotating equipment, reducing leak points and protecting internal components while maintaining compatibility with legacy assemblies. Installers and maintenance managers will appreciate the precise dimensions and straightforward replacement procedure that minimize downtime.
LongDescription#@#NA#@@#Cleaning Instructions#@#Clean the motor seal after each service shift to prevent contamination of clean items and hands and to deter pests. Use a soft cloth with mild detergent and warm water; scrub the seal groove gently and rinse thoroughly. Sanitize with an EPA-registered surface disinfectant when Norovirus risk exists. Inspect for cracks or wear and replace immediately if damaged. Follow manufacturer torque specs during reassembly to preserve seal life and maintain compliance with CSA and health standards.#@@#Additional Info#@#PartsTown 990060800 motor seal fits foodservice motors, measures 1.6 in length and 0.5 in height, and weighs 0.02 pounds. Technicians install the HAM990060800 to restore sealing integrity and prevent lubricant loss.#@@#General Info#@#Description #@#
Stop compromising uptime for convenience. This motor seal restores drive integrity in mixers and rotating equipment, reducing leak points and protecting internal components while maintaining compatibility with legacy assemblies. Installers and maintenance managers will appreciate the precise dimensions and straightforward replacement procedure that minimize downtime.
#@@# Seal Diameter#@#
This motor seal measures 1.6 inches in outer length and 0.5 inches in thickness, providing a compact profile that fits confined housings. Technicians can rely on these exact measurements to verify compatibility before service, reducing trial-and-error downtime.
#@@# Material Compatibility#@#
The component resists common lubricants and cleaning agents used in commercial kitchens, protecting internal bearings and windings. Maintenance staff can operate equipment with confidence, knowing the seal prevents ingress that leads to premature wear.
#@@# Leak Prevention#@#
Engineered to create a secure barrier between shaft and housing, the seal reduces fluid migration that causes corrosion and electrical faults. Facilities equipment runs cleaner, lowering the frequency of corrective repairs and associated labor hours.
#@@# Installation Ease#@#
Designed for direct replacement, the part installs with standard hand tools and requires no custom machining, facilitating rapid turnaround during scheduled maintenance windows. Crews can perform swaps on-site, restoring equipment to service within a single shift.
#@@# Weight and Handling#@#
At approximately 0.02 pounds, the seal offers negligible added load on rotating assemblies and simplifies inventory management for parts rooms. Operators can stock multiple units without impacting shelf capacity or shipping costs.
#@@# Regulatory Traceability#@#
Provided by PartsTown with part number HAM990060800, the seal supports traceable procurement and warranty documentation for institutional buyers.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect the 990060800 MOTOR SEAL monthly for nicks, cracks, and deformation. Remove the motor housing per manufacturer instructions and clean mating surfaces with isopropyl alcohol to remove grease and debris. Replace the seal if wear exceeds 0.5 mm or if leakage appears. Apply a thin film of compatible lubricant to seating areas before installation. Tighten fasteners to specified torque and run a leak test under normal load for 30 minutes.