The dilution hose and blower assembly delivers consistent performance in demanding foodservice environments, enabling controlled flow and reliable operation across long service runs. Designed for parts replacement and system maintenance, this component supports uptime and predictable dilution ratios for calibration and daily use.
LongDescription#@#NA#@@#Cleaning Instructions#@#Wipe the 52103 dilution hose/blower with a soft cloth and mild detergent; rinse with clean water and dry. Sanitize high-touch zones like hose ends and mounting points using EPA-registered sanitizer per label dilution rates. Inspect for cracks or wear; replace if damaged. Clean daily in dining and prep areas to prevent contamination, deter pests, maintain compliance with CSA and health codes, and extend equipment life.#@@#Additional Info#@#PartsTown HEN52103 dilution hose/blower S is 17.45" long, 4.1" wide, and 4.1" high, weighing 0.46 pounds. It attaches to standard blowers, maintains dilution rates, resists corrosion, and meets CSA safety standards.#@@#General Info#@#Description #@#
The dilution hose and blower assembly delivers consistent performance in demanding foodservice environments, enabling controlled flow and reliable operation across long service runs. Designed for parts replacement and system maintenance, this component supports uptime and predictable dilution ratios for calibration and daily use.
This hose measures 17.45 inches in length and a nominal diameter that suits compact blower interfaces, enabling straightforward routing in tight equipment layouts. Technicians will appreciate the manageable size when integrating the part into existing systems.
The assembly stands at 4.1 inches by 4.1 inches for width and height, allowing installation where space limits access. Engineers can position the unit near mixers, pumps, or dispensers without extensive cabinet modification.
The component weighs 0.46 pounds, reducing strain during installation and service cycles. Service crews will complete swaps faster and with reduced risk of handling fatigue.
Manufactured for commercial repair applications, the hose and blower resist routine wear common in high-use settings. Maintenance teams will extend service intervals when they replace degraded lines with robust, specification-matched parts.
PartsTown supplies this replacement part under a manufacturer part number HEN52103 and maintains traceability for procurement records. Purchasing agents and inventory managers will retain documentation for audit and warranty purposes.
The part integrates with standard dilution systems used across institutional and hospitality operations, supporting calibration to target ratios in gallons or liters as specified by system guidelines. Operations staff will restore precise control over flow rates after installation.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Service personnel should inspect the 52103 DILUTION HOSE/BLOWER S for kinks and abrasions weekly and replace if fittings show corrosion. Clean exterior surfaces with a neutral detergent and rinsing water; avoid solvents that degrade elastomers. Verify secure connections and clamp torque monthly. Flush with potable water after chemical use; record gallons or liters used during flushing. Calibrate blower alignment quarterly and log serial UID HEN52103 and CSA compliance where applicable.