Manufacturing follows industry standards and uses materials compatible with foodservice sanitation protocols, including CSA relevant practices where applicable. Procurement teams gain confidence in component traceability and regulatory alignment.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug dispensing lines and depressurize the keg before disconnecting. Remove coupler and soak in a solution of 1/4 cup sanitizer per gallon of warm water; scrub probe and body with a soft brush to remove beerstone and residue. Rinse with potable water and air dry. Inspect seals and replace worn gaskets. Clean couplers after each keg change to prevent contamination, reduce fire risk from buildup, and extend equipment life.#@@#Additional Info#@#Micro Matic 7486SS S System keg coupler has a 304 stainless steel body and probe for durability, a Gray finish, CSA compatibility, and precise valve engagement for easy connection, cleaning, and consistent beverage flow.#@@#General Info#@#Description #@#
Manufacturing follows industry standards and uses materials compatible with foodservice sanitation protocols, including CSA relevant practices where applicable. Procurement teams gain confidence in component traceability and regulatory alignment.#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect the Micro Matic 7486SS coupler daily for wear and residue on the stainless steel body and probe to prevent contamination. Remove the coupler, flush with warm water and neutral pH detergent, then rinse thoroughly to avoid sanitizer residues. Sanitize with a food-safe solution per manufacturer instructions and air dry before reassembly. Check O-rings and seals at each service interval and replace if deformed. Verify thread engagement and torque during reinstallation for a tight seal.
