Engineered for rigid wall-mounted shelving, this shelf support delivers consistent alignment and load stability for 18-inch deep shelves in commercial kitchens and storage rooms. Designed to integrate with Super Erecta wire and solid shelves as well as MetroMax Q and MetroMax i systems, it ensures repeatable installation and simplifies shelf layout planning. Users benefit from a corrosion-resistant epoxy finish and antimicrobial protection that reduce maintenance and extend usable life.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug equipment and remove loose debris. Spray a food-safe detergent on shelf supports and wire components, scrub with a nylon brush, rinse with potable water, and dry with a lint-free cloth. Inspect for corrosion, loose fasteners, and worn seals; tighten or replace parts as needed. Clean vents and coils monthly to prevent grease buildup and reduce fire risk. Document each cleaning to maintain CSA and health inspection records.#@@#Additional Info#@#Metro SWS18K4 SmartWall shelf support fits 18" deep shelves with two supports per shelf.#@@#General Info#@#Description #@#
Engineered for rigid wall-mounted shelving, this shelf support delivers consistent alignment and load stability for 18-inch deep shelves in commercial kitchens and storage rooms. Designed to integrate with Super Erecta wire and solid shelves as well as MetroMax Q and MetroMax i systems, it ensures repeatable installation and simplifies shelf layout planning. Users benefit from a corrosion-resistant epoxy finish and antimicrobial protection that reduce maintenance and extend usable life.
#@@# Shelf Interface#@#
Mounting geometry fits 18-inch deep shelving profiles and matches common Super Erecta and MetroMax connectors for straightforward attachment. Installers achieve accurate shelf placement with the support plate dimensions of 20.56 inches by 1.5 inches by 8.19 inches, minimizing alignment rework during buildout.
#@@# Corrosion Resistance#@#
Metroseal Gray epoxy coating resists rust in humid kitchen and backroom environments, protecting structural integrity over continuous use. Maintenance teams require less surface treatment and experience fewer failures from environmental degradation.
#@@# Antimicrobial Protection#@#
Microban antimicrobial additive inhibits microbial growth on the coated surface, lowering contamination risk on high-touch shelving components. Food safety managers gain an additional control layer without altering cleaning protocols.
#@@# Load Compatibility#@#
Specification lists a nominal capacity of 0.23 pounds per single support, and system designers should plan two supports per shelf to achieve balanced support and redundancy. Planners must account for intended loads and place supports at recommended intervals to maintain structural performance.
#@@# Durable Construction#@#
Stamped steel construction yields dimensional stability and resists bending under typical commercial loads when installed per manufacturer guidance. Facilities teams will find the supports retain alignment across repeated shelf adjustments.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Install the Metro SWS18K4 shelf support using two units per 18" shelf and fasten to SmartWall per manufacturer torque specs. Inspect epoxy-coated surfaces monthly; remove debris with a soft brush and mild detergent to preserve Metroseal Gray finish and Microban® protection. Verify level and load distribution before service; do not exceed rated 0.23 pounds per support. Replace supports showing corrosion or deformation immediately to maintain structural safety.