The disposer is engineered for sustained use in high-volume kitchens. Operators will benefit from a robust 10 HP motor that efficiently handles grinding tasks. Managers will appreciate the durable construction that minimizes downtime and supports long service intervals.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug power and lock out the 3-Ph circuit before servicing the Insinger G-1000L-3. Remove debris from the 7" throat and inspect the 15" rotor for wear. Flush with warm water and a mild detergent; scrub with a non-abrasive brush. Clean cast iron housing and connector sleeve; tighten clamps to spec. Check condenser coils and ventilation to reduce grease buildup and fire risk. Verify door seals and electrical amps (33) after drying, then restore power and test operation.#@@#Additional Info#@#Insinger’s G-1000L-3 disposer features a 10 HP, 3-Ph motor at 208/220 volts, 33 amps, 7" inlet, 15" rotor, and cast iron housing for commercial use. It mounts with a connector sleeve and clamps, is CSA listed, and weighs 310 pounds.#@@#General Info#@#Description #@#
The disposer is engineered for sustained use in high-volume kitchens. Operators will benefit from a robust 10 HP motor that efficiently handles grinding tasks. Managers will appreciate the durable construction that minimizes downtime and supports long service intervals.
A 7 throat size allows for large input without frequent jamming or pre-cutting, enhancing processing speed. Technicians will find the connector sleeve and clamps facilitate plumbing integration and streamline installation.
The 10 HP motor provides continuous torque for heavy waste loads, enabling kitchens to maintain consistent processing volumes during peak periods. Engineers can anticipate 33 amps at 208/220v, 3-Ph, for effective electrical planning and load management.
The cast iron housing ensures structural rigidity and thermal mass to endure repeated cycles and resist deformation. The cast alloy body and rotor work together for efficient material reduction and mechanical durability.
Designed for 208/220 volts at 60 hertz and three-phase operation, the unit aligns with typical commercial power distributions. Electricians can utilize the specified amp draw for sizing breakers and conductors for compliant installation.
The basic unit is ready for field configuration, allowing facilities to incorporate controls or safety interlocks as needed. Maintenance staff will find the straightforward design simplifies parts management and facilitates routine inspections.
The disposer weighs approximately 310 pounds and occupies minimal vertical space while delivering industrial throughput. Facility planners can balance weight with mounting and vibration isolation requirements to ensure secure installation.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect the Insinger G-1000L-3 disposer weekly for flange and clamp integrity and tighten fasteners to specified torque values. Drain and flush lines with a warm water rinse after heavy use to prevent buildup. Lubricate motor bearings per manufacturer intervals and verify electrical connections at 208/220 volts, 3-Ph, 33 amps. Replace worn rotor or seals promptly. Document service dates and CSA inspection results for compliance and traceability.
