Step up cold storage capacity without compromising control or durability. This outdoor walk-in freezer delivers consistent low-temperature performance with a 2 HP hermetic refrigeration package and pre-charged R-448A refrigerant, engineered to maintain -10° F operation for frozen inventory. Field-ready construction pairs an acrylume interior and exterior with foamed-in-place 4" urethane floor panels to provide thermal integrity and simplified serviceability.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug power and lock out the circuit before servicing. Remove product and defrost per guidelines. Wipe Acrylume surfaces with mild detergent and warm water, rinse, and dry. Clean condenser coils and evaporator fins regularly to maintain efficiency. Degrease door gaskets and hinges; inspect seals and replace if cracked. Clear roof drains and vents to prevent moisture damage. Document cleaning and record temperatures to pass CSA and health inspections.#@@#Additional Info#@#American Panel's 8X8F-O walk-in freezer is 93" W x 90" H with Acrylume interior, 4" urethane floor panels, vinyl roof, hinged door, and vapor-proof light.#@@#General Info#@#Description #@#
Step up cold storage capacity without compromising control or durability. This outdoor walk-in freezer delivers consistent low-temperature performance with a 2 HP hermetic refrigeration package and pre-charged R-448A refrigerant, engineered to maintain -10° F operation for frozen inventory. Field-ready construction pairs an acrylume interior and exterior with foamed-in-place 4" urethane floor panels to provide thermal integrity and simplified serviceability.
#@@# 2 HP Refrigeration#@#
A 2 HP hermetic compressor matched to a pre-charged R-448A remote refrigeration circuit provides sustained low-temperature output for large frozen loads. Designers included Quick Response controller compatibility and standard winterization controls to ensure reliable operation in variable climates.
#@@# Remote Condensing System#@#
Remote refrigeration architecture places the condensing unit off the walk-in, reducing on-site heat load and simplifying mechanical room layout. Technicians access the condensing unit at 208v/60/1-ph with a 17.1 amp draw, while evaporator motors draw 0.9 amps and heater circuits draw 4.3 amps, allowing precise planning for electrical infrastructure.
#@@# Durable Panel Construction#@#
Acrylume-faced panels on both interior and exterior resist corrosion and streamline cleaning in heavy-use environments. Factory-foamed 4" urethane core minimizes thermal bridging and reduces energy consumption compared with thinner assemblies.
#@@# Built-In Floor System#@#
Integrated foamed-in-place floor panels deliver a reinforced walking surface rated for commercial foot traffic and pallet handling. Floor assembly installs with the same thermal envelope as wall panels, maintaining continuous insulation from slab to ceiling.
#@@# Weather-Resistant Roof#@#
A vinyl membrane rain roof protects the top of the unit in outdoor installations and directs water away from seams. Roof detailing pairs with camlift hinged door hardware to preserve seal integrity under frequent use.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect door gaskets weekly; replace any with cracks or compression loss to maintain thermal integrity. Drain condensate and check floor panel seals monthly to prevent water intrusion and insulation damage. Clean condenser and evaporator coils every three months with a soft brush and low-pressure air to preserve efficiency. Test dial thermometer and functional alarm quarterly; recalibrate or repair controllers as needed.