Stop sacrificing durability for ease of installation. This front cross brace installs quickly on compatible commercial sinks to restore structural rigidity and maintain alignment under heavy use, reducing leg movement and long-term wear. Professionals will value the precise fit and documented compatibility with FC, FS, and FE series sinks for both retrofit and new builds.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug or shut off equipment before cleaning. Remove debris and scrub surfaces with a mild detergent and warm water; rinse thoroughly. Use non-abrasive tools on coated metals. Degrease ovens, vents, and hoods with approved solvents; rinse and dry. Clean condenser coils and refrigeration gaskets monthly to improve efficiency. Sanitize food-contact surfaces with EPA-registered sanitizer at labeled dilution. Inspect seals and replace worn parts. Document cleaning dates and responsible staff.#@@#Additional Info#@#Advance Tabco FC-CB-1-X front cross brace reinforces FC, FS, and FE series sinks. Technicians install it by disconnecting plumbing. It fits sinks three feet or longer, weighs 2 pounds, meets CSA certification, and supports kitchen durability.#@@#General Info#@#Description #@#
Stop sacrificing durability for ease of installation. This front cross brace installs quickly on compatible commercial sinks to restore structural rigidity and maintain alignment under heavy use, reducing leg movement and long-term wear. Professionals will value the precise fit and documented compatibility with FC, FS, and FE series sinks for both retrofit and new builds.
#@@# Mounting Compatibility#@#
Designed for FC, FS, and FE series sink frames, this cross brace fits installations where the sink measures a minimum of 3 feet across. Installers should use the sink's overall length and subtract any drainboard length to calculate the required feet and brace placement, ensuring accurate ordering and straightforward field fitment.
#@@# Retrofit Preparation#@#
Field retrofit requires plumbing disconnection before installation; technicians must isolate and secure supply and drain lines to prevent damage. Prepare the workspace with standard stainless-steel fastening tools and verify sink frame clearance to avoid interference during brace placement.
#@@# Structural Reinforcement#@#
Engineers designed the brace to restore lateral rigidity to leg assemblies and reduce deformation under load, protecting welded joints and fasteners. Operators will notice reduced wobble during peak use, which preserves sink alignment and extends service life.
#@@# Material Specification#@#
Manufacturers produced the unit from corrosion-resistant materials suitable for frequent washdown and chemical exposure in foodservice environments. Maintenance staff can clean the brace with standard detergents and sanitizers while complying with routine kitchen hygiene protocols.
#@@# Weight and Handling#@#
Weighing approximately 2 pounds, the brace remains compact and easy for a single technician to maneuver during installation. Handlers will appreciate the low mass when positioning the unit beneath the sink frame, minimizing the need for additional lifting equipment.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Install the Advance Tabco FC-CB-1-X front cross brace according to manufacturer guidelines to maintain sink rigidity. Inspect welds and fasteners monthly and tighten bolts to specified torque. Remove plumbing before retrofit and verify proper support during installation. Clean stainless surfaces with pH-neutral detergent and rinse to prevent corrosion. Lubricate adjustment points lightly and replace damaged braces immediately to ensure safe, stable operation.
