Reliable hot water on demand keeps operations moving during service rushes. This tankless electric unit delivers a continuous flow of 0.5 gpm with a 42-degree rise at rated flow, ensuring consistent wash and hand sink performance without the footprint of a storage tank. Facilities save valuable floor space while meeting health code requirements through wall mounting or factory pedestal integration when ordered with a compatible sink.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug electrical power before cleaning. Drain and flush lines with clean water to remove deposits. Use a mild detergent and soft cloth on exterior surfaces; avoid abrasive pads. Clean inlet screens and strainers monthly to maintain 0.5 gpm flow. Inspect electrical connections and seals for wear; tighten or replace as needed. Remove scale with manufacturer-approved descaler when temperature rise drops. Dry all components fully before restoring power to prevent short circuits.#@@#Additional Info#@#Advance Tabco 7-PS-92 tankless electric water heater offers 0.5 gpm flow at 120 volts and 3,000 watts, raising water temperature by 42°F. It mounts on a wall or pedestal, needs cold water feed, and a 25-amp circuit. CSA listed.#@@#General Info#@#Description #@#
Reliable hot water on demand keeps operations moving during service rushes. This tankless electric unit delivers a continuous flow of 0.5 gpm with a 42-degree rise at rated flow, ensuring consistent wash and hand sink performance without the footprint of a storage tank. Facilities save valuable floor space while meeting health code requirements through wall mounting or factory pedestal integration when ordered with a compatible sink.
#@@# Flow Capacity#@#
Engineered for a maximum continuous flow of 0.5 gpm, the unit supplies stable hot water for individual sinks and low-flow fixtures. Operators gain predictable temperature rise and consistent output for rinsing and sanitation tasks, enhancing overall efficiency.
#@@# Temperature Performance#@#
The heater raises incoming cold water by approximately 42 degrees at the rated flow, enabling reliable warm water delivery at 120v electrical service. Maintenance staff can set expectations for wash cycles and sanitizer effectiveness based on this documented temperature increase, ensuring compliance with health standards.
#@@# Electrical Specification#@#
Designed for 120v single-phase circuits, the unit draws 25 amps and operates at 3000 Watts, requiring a properly sized circuit breaker installed by qualified electricians. Facility engineers should verify panel capacity and branch circuit protection before installation to ensure safety and functionality.
#@@# Mounting Flexibility#@#
Wall mounting allows for compact installation in tight utility rooms and behind service counters, while factory pedestal mounting remains an option when ordered with a matching sink. Service teams benefit from reduced installation complexity when the manufacturer pre-mounts the unit inside the pedestal, streamlining the setup process.
#@@# Compliance and Certification#@#
This model carries NSF certification, supporting compliance with foodservice sanitation standards and simplifying health inspections.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect electrical connections monthly and tighten terminals to maintain 120v supply integrity. Flush inlet strainers quarterly to prevent sediment buildup and sustain 0.5 gpm flow. Verify wall mounting brackets and fasteners semiannually for secure support. Measure outlet temperature under 0.5 gpm load to confirm approximately 42 degrees rise; adjust piping or pressure if deviation exceeds 5 degrees. Replace worn seals and document maintenance dates for CSA compliance.
