Stop settling for makeshift repairs when uptime and seal integrity determine line performance. This mixer seal assembly provides a precise replacement that restores mixing head containment and prevents product loss, contamination, and downtime. Technicians install the unit quickly to return equipment to service and maintain consistent processing cycles.
LongDescription#@#NA#@@#Cleaning Instructions#@#Clean the 58507 SEAL SAS MIXER ASSEMBLY with a soft cloth and mild detergent diluted in warm water, removing food residue and grease from seals and housing. Rinse with clean water and dry thoroughly to prevent corrosion. Sanitize high-touch zones like control knobs and external handles using an approved surface sanitizer. Inspect seals for wear and replace as needed to avoid contamination of food and hands, reduce pest attraction, and extend serviceable life of equipment.#@@#Additional Info#@#PartsTown SS58507 SEAL SAS mixer assembly fits commercial mixers, measuring 2.6" x 2.6" x 0.7", weighs 0.01 pounds, and installs to restore performance; CSA-listed components ensure compliance and reduce downtime.#@@#General Info#@#Description #@#
Stop settling for makeshift repairs when uptime and seal integrity determine line performance. This mixer seal assembly provides a precise replacement that restores mixing head containment and prevents product loss, contamination, and downtime. Technicians install the unit quickly to return equipment to service and maintain consistent processing cycles.
#@@# Seal Reliability#@#
Engineered to match OEM tolerances, the assembly restores sealing surfaces to original specifications and reduces leakage risk during high-speed operation. Maintenance teams eliminate trial fitting with a direct-fit design that minimizes installation time and aligns with existing mixer housings.
#@@# Precise Dimensions#@#
Manufactured to a 2.6-inch length and 0.7-inch height profile, the component fits compact mixer shafts and accommodates tight clearance conditions common in commercial kitchens and processing lines. Service crews rely on those measurements to verify compatibility before disassembly.
#@@# Lightweight Construction#@#
Weighing approximately 0.01 pounds, the assembly simplifies handling during swap-outs and reduces strain on shaft bearings caused by heavier aftermarket parts. Technicians perform faster changeovers and maintain rotor balance without additional counterweights.
#@@# Material Compatibility#@#
The part uses materials compatible with food processing environments and common cleaning agents, supporting frequent sanitation cycles without rapid degradation. Operators maintain hygienic contact surfaces and comply with routine washdown procedures.
#@@# Traceable Identification#@#
Tagged with a manufacturer part number and UID, the assembly supports inventory control and reorder accuracy for procurement teams. Facilities minimize misorders by referencing the SS58507 identifier during purchasing and stocking.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Replace the 58507 SEAL SAS MIXER ASSEMBLY at scheduled intervals to prevent leaks and maintain efficiency. Inspect shaft seals weekly and tighten fasteners to specified torque. Lubricate bearings with approved lubricant every 500 hours. Flush surfaces with warm water and mild detergent after use; dry completely before reassembly. Verify alignment within 0.5 mm and test for unusual vibration or noise. Maintain records for CSA compliance and traceability.
