Stop sacrificing fit for function. This rubber venting component provides a precise seal and reliable airflow control for commercial kitchen exhaust systems, delivering consistent performance where ventilation integrity affects safety and compliance. Designed for frequent installation and service environments, it balances flexibility with dimensional stability to reduce maintenance time and prevent leakage.
LongDescription#@#NA#@@#Cleaning Instructions#@#Wipe the rubber venting pipe with a soft cloth and mild detergent solution; rinse with clean water and dry immediately. Sanitize high-touch zones like pipe ends and nearby handles using EPA-registered disinfectant per label dwell time. Inspect for cracks or deformation; replace if damaged. Clean weekly or after heavy soil to prevent contamination transfer to staff and customers, deter pests, and maintain equipment life. Founded 1998, CSA-compliant practices support inspections.#@@#Additional Info#@#PartsTown fabricates a 54.00.094 rubber venting pipe for foodservice equipment. It measures 5.6" long, 8.35" wide, 2.75" high, weighs 0.3 pounds, and meets CSA standards for reliable sealing and easy replacement.#@@#General Info#@#Description #@#
Stop sacrificing fit for function. This rubber venting component provides a precise seal and reliable airflow control for commercial kitchen exhaust systems, delivering consistent performance where ventilation integrity affects safety and compliance. Designed for frequent installation and service environments, it balances flexibility with dimensional stability to reduce maintenance time and prevent leakage.
#@@# Material Resilience#@#
Manufactured from molded rubber formulated for heat and chemical resistance, this piece withstands routine exposure to cooking effluent and cleaning agents. Installers will note reduced hardening and fewer replacement cycles compared with generic elastomers.
#@@# Dimensional Accuracy#@#
Engineered to nominal dimensions of 5.6 inches in length, 8.35 inches in width, and 2.75 inches in height, the component fits specified venting geometries without field modification. Technicians avoid on-site trimming and gain repeatable alignment during rapid exchange.
#@@# Low Mass Design#@#
With a unit weight near 0.3 pounds, the part adds minimal load to duct assemblies and mounting brackets. Service teams experience easier handling during installation and reduced strain on support hardware.
#@@# Service Compatibility#@#
Produced to integrate with established venting assemblies, the form piece matches common pipe interfaces used in commercial exhaust systems. Maintenance managers can stock this item as a direct-replacement part and minimize system downtime.
#@@# Operational Safety#@#
The flexible form conforms to mating surfaces to maintain airtight connections, reducing the risk of exhaust leaks and preserving negative-pressure balance. Facility engineers gain improved control over airflow paths and reduce contaminant spread.
#@@# Traceability and Sourcing#@#
Supplied by an established parts distributor founded in 1998, the component carries a manufacturer part number for inventory control and ordering accuracy.
#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#NA#@@#Maintenance Guide#@#Inspect the rubber venting piece monthly for cracks or deformation and replace when wear exceeds 10% of cross-section to prevent leaks. Clean with mild detergent and warm water; avoid solvents that swell rubber. Dry components thoroughly before reassembly. Verify secure seating on pipe fittings and tighten clamps to manufacturer torque specifications. Record maintenance actions, part UID RATL54.00.094 and thgpidnumber 54.00.094 for inventory control and CSA compliance.
