The kit ships at approximately 2.64 pounds, which crews handle safely during service and maintenance tasks without specialized lifting tools. Staff complete installations with standard hand tools and minimal training, accelerating return to service.
LongDescription#@#NA#@@#Cleaning Instructions#@#Unplug the slicer and remove blades carefully. Wear cut-resistant gloves. Disassemble the Vollrath 15050 wedger kit and soak parts in warm water with a mild detergent for 10–15 minutes. Scrub with a soft brush to remove pulp and grease, rinse in clean water, and air dry or towel dry completely. Sanitize food-contact surfaces per CSA or local guidelines. Reassemble and verify secure fit. Clean daily to prevent bacteria, fires from grease buildup, higher energy use, and equipment failure.#@@#Additional Info#@#Vollrath 15050 four-section wedger fits Redco Instacut 3.5 cutters, supplied in a pack for quick service; CSA-listed, 2.#@@#General Info#@#Description #@#
The kit ships at approximately 2.64 pounds, which crews handle safely during service and maintenance tasks without specialized lifting tools. Staff complete installations with standard hand tools and minimal training, accelerating return to service.#@@#Delivery Details#@#
• Please ensure to handle the product with utmost care.
• Check if the product you have received has all the essential parts and accessories.
• Make sure to examine the product for damage before signing the delivery receipt.
• Contact customer service for delivery concerns.
• Delivery times may vary based on location.#@@#deliverynotes#@#Ensure compatibility with the Redco InstaCut™ 3.5 before ordering. Visit Vollrath’s website for warranty information.#@@#Maintenance Guide#@#Refer to Vollrath installation instructions and inspect each wedger before use to confirm integrity and fit for the Table Top Redco Instacut 3.5. Remove food debris after each shift; soak components in warm, soapy water and brush joints to dislodge particles. Sanitize with a food-safe chemical per manufacturer recommendations. Lubricate pivot points with an NSF-registered lubricant monthly. Verify alignment and fasteners; tighten to specified torque values.
